Our ‘Buses & Cycles Route’ preformed thermoplastic road marking is one of our markings which is commonly used to help increase traffic flow in busy areas. As the roads become busier there is a requirement for more bus and cycle routes. This marking can be used to indicate routes that are for buses and pedal cycles only.

You could also use this marking in combination with a bus and cycle route post mounted sign to highlight the route set for cyclist. Post mounted road signs can be found in our signage section here.

Key Features:

• Easy Application - No special knowledge, talent or years at art school required, just a clean surface and a gas burner. Just place the marking bead side up and apply heat till fully melted onto the surface.
• Professional Appearance - These markings always look good due to their pre-cut design.
• Fast To Install - Minimal surface preparation is required for these markings, with a worst-case scenario requiring an application of primer.
• Non-Slip - No need to apply glass bead to these markings as it comes embedded in them.
• Conforms - BSEN 1871